For those who demand the best Ask Averto
|Size||210 x 700 x 0.4 cm|
|Floor area||14.7 m2|
|Packaging||1 x 210 x 110 x 110 cm = 14 kg|
Size 210 x 700 x 0.4 cm
Area 14.7 m2
Material 4 mm Polycarbonate
Weight 14 kg
Packaging 210 x 110 x 110 cm = 14 kg
Protection against UV-radiation. Sheet is being produced on very modern equipment that allows consistent even and equal protection layers.
Sheet is covered by a 10 years warranty against ageing by outside weathering. This warranty against loss of light transmission, excessive yellowing and breakage of the sheet by hail impact is available on demand.
During installation of sheet all necessary arrangements should be taken to ensure safe working conditions in line with the health and safety or SHE regulations. Never walk on the sheet during installation or maintenance. Use appropriate boards, placed on the purlins, to support the weight. When lifting sheets on to the roof, use wide belts to distribute the load correctly.
Sheet should be handled with care to prevent damage and scratching. Lifting with forklifts must always be done on the wooden pallets as support, never directly on the sheet. The masking film protects the sheet surface against scratches and should be removed only just prior to the actual installation. Never walk on a stack of sheet.
The sheet needs to be installed according to prescribed and commonly used practices. For most roofing applications, the sheet will either need to be installed flat, with a minimum slope of 5 degrees, or curved. In this last case, it is important not to overstretch the sheet as this will cause premature failure due to cracking. It will also increase the damaging effect of any UV attack as well as hail stones damage.
During mounting process it is necessary to anticipate some space for thermal expansion, not less than 2.5 mm for every meter of length and width for transparent sheet and 4 mm for colored sheet. It will help to avoid kinking and internal thermal expansions. ace should be anticipated in length and in width.
Before installing the sheet in the profiles, care should be taken to prevent contamination of the internal channels. Therefore the channels need to be closed with an adhesive tape. This tape will prevent dust and water to enter the sheet and cause optical problems.
Product descriptions provide basic information, but sometimes you may have an unusual question about the product, its delivery or payment system. By using our contact form, you can ask questions or express your wishes. Get in touch with us and a detailed response will be sent to your e-mail address!